Content
Abstract:
Today, illumination systems use approximately 1/3 of the electrical energy produced. For this reason, new technologies constantly increase energy efficacy in illumination technology. Consequently, the use of LED type light sources gets more widespread with low power electronics-based versions. The most important advantage of this type of systems has high luminous efficacy. However, since electronic systems have non-linear static loads, they cause unwanted harmonics in electrical distribution systems. Harmonics affect the operational safety as they cause unnecessary heating of the conductors in the electrical network. It also adversely affects the measuring and control systems of the buyers and so decreases the energy performance. In this study, an adaptive Butterworth low pass active harmonic filtermodel that can cut all current/voltage harmonics outside the operating frequency of different types of LED driver light sources is designed. In addition, harmonic analysis of different LED driver systems is performed experimentally by considering the total harmonic distortions (THD,%). In this way, harmonic components and (THD) values of different LED systems are obtained. These harmonic components obtained is filtered with the designed filter structure and the effects of the filter structure at each filtering degree on the harmonic components and THD were investigated. In this way, the designed filter is proved to be an adaptive model that can be adjusted automatically for different types of LED systems.
References:
1. Singh, R. Energy loss due to harmonics in residential campus-a case study // In proceedings of the 45th International Universities Power Engineering Conference UPEC2010, Cardiff, UK, 2010 2. Simpson, R.H. Misapplication of power capacitors in distribution systems with non-linear loads-three case histories // IEEE Trans. Ind. Appl. 41, 2005, pp. 134–143. 3. Abdelmessih, G. Z., Alonso, J.M. et al. Fully Integrated Buck and Boost Converter as a High Efficiency, High-Power-Density Off-Line LED Driver // IEEE Transactions On Power Electronics, 2020, Vol. 35, #11, pp. 12238–12251. 4. Ozgonenel, O., Terzi, U.K., Khan, A. A hybrid approach for power quality monitoring // Turk J Elec Eng & Comp Sci, 2012, Vol. 20, #6, pp. 854–869. 5. Samadaei, E., Iranian M., Rezanejad, M., Godina R., Pouresmaeil E. Single-Phase active power harmonics filter by op-amp circuits and power electronics devices // Sustainability, 2018, Vol. 10, p. 4406. 6. Shyni, S. M., Simon, J. et al. Implementation of Integrated SEPIC-Flyback Converter for LED Drive with Efficient Power Factor // IEEE, Fourth International Conference on Electronics, Communication and Aerospace Technology (ICECA‑2020), pp. 385–389. 7. Akagi, H. Modern active filters and traditional passive filters // Bull. Pol. Acad. Sci. Tech. 54, 2006, pp. 255–269. 8. Lee, Y. J., Niou, C.P. et al. A Digital Power Factor Controller for Primary-Side-Regulated LED Driver // IEEE Access, 2020, Vol. 8, pp. 21813–21822. 9. Beres, R. N., Wang, X., Liserre, M., Blaabjerg, F., Bak, C.L. A review of power filters for three-phase gridconnected voltage-source converters // IEEE J. Emerg. Sel. Top. Power Electron, 2016, #4, pp. 54–69. 10. Badrzadeh, B., Smith, K.S., Wilson, R.C. Designing passive harmonic filters for an aluminum smelting plant // IEEE Trans. Ind. Appl. 2011, Vol. 47, pp. 973–983. 11. Zhang, J., Zhao, C., Zhao, S., Wu, X. A family of single-phase hybrid step-down PFC converters // IEEE Trans. Power Electron, 2017, Vol. 32, pp. 5271–5281. 12. Liu, Y., Sun, Y., Su M., Zhou, M., Zhu, Q., Li, X. A Single-phase PFC rectifier with wide output voltage and low-frequency ripple power decoupling // IEEE Trans. Power Electron, 2018, Vol. 33, pp. 5076–5086. 13. Xueshan, L., Yuyang, W., Zheng, D. et al. Buck–Boost–Buck-Type Single-Switch Multistring Resonant LED Driver with High Power Factor and Passive Current Balancing // IEEE Transactions on Power Electronics, 2020, Vol. 35, #5, pp. 5132–5143. 14. Abdelmessih, G. Z., Alonso, J. M., Costa, M.A.D. Electrolytic-Capacitor-less Off-Line LED Driver based on Integrated Parallel Buck-Boost and Boost Converter // 2020 IEEE Industry Applications Society Annual Meeting |978–1–7281–7192–0/20/$31.00 ©2020 IEEE 15. Javadi, A., Al-Haddad, K. A single-phase active device for power quality improvement of electrified transportation // IEEE Trans. Ind. Electron, 2015, #62, pp. 3033–3041. 16. Antchey, M.H. Classical and recent aspects of active power filters for power quality improvement in classical and recent aspects of power system optimization // Academic Press: Cambridge, USA, 2018, pp. 219–254. 17. Samadaei, E., Lesan, S., Cherati, S.M. A new schematic for hybrid active power filter controller // In Proceedings of the 2011 IEEE Applied Power Colloquium (IAPEC), Johor Bahru, Malaysia, 18–19 April 2011, pp. 143–148. 18. Singh, B., Solanki, J. An implementation of an adaptive control algorithm for a three-phase shunt active filter // IEEE Trans. Ind. Electron, 2009, Vol. 56, pp. 2811–2820. 19. Kanjiya, P., Khadkikar, V., Zeineldin, H.H. Optimal control of shunt active power filter to meet // IEEE Std. 519 current harmonic constraints under nonideal supply condition. IEEE Trans. Ind. Electron, 2011, Vol. 62, pp. 724–734. 20. Cikai, Y., Chan, H. W., Dongdong, L. et al. Efficiency Improvement of Multichannel LED Driver with Selective Dimming // IEEE Transactıons on Power Electronıcs, 2020, Vol. 35, #6, pp. 6280–6291. 21. Huan, L., Sinan, L. et al. Single-Phase LED Driver with Reduced Power Processing and Power Decoupling // IEEE Transactions On Power Electronics, 2021, Vol. 36, #4, pp. 4540–4548. 22. Giurgiutiu, V. Chaper‑14: signal processing and pattern recognition for structural health monitoring with PWAS transducers // Structural Health Monitoring with Piezoelectric Wafer Active Sensors, Second Edition, 2014, pp. 807–862. 23. Morán, L., Dixon, J. Active filter. Third Edition, Editor: Rashid // H.M. Power elektronik handbook devices circuits and applications, USA, Butterworth – einemann publications, ISBN978–0–12–382036–5, 2011, pp. 1193–1228. 24. Fadloullah, I., Mechaqrane, A., Ahaitouf, A. Butterworth lowpass filter design using evolutionary algorithm // IEEE2017 International Conference on Wireless Technologies, Embedded and Intelligent Systems (WITS) 978–1–5090–6681–0/17. 25. Laghari, W. M., Baloch, M.U., Mengal, M.A., Shah, S.J. Performance analysis of analog butterworth lowpass filter as compared to Chebyshev type-I filter // Chebyshev type-II filter and elliptical filter, Circuits and Sytems, 2014, Vol. 5, pp. 209–216.
Keywords
Recommended articles
Luminance Measurement and Estimation Methods in Road L&E, Vol.30, No.6, 2022