Content
Abstract:
LED luminaires need a driver circuit for working properly. Most of the drivers have disadvantages such as losses during operation. This issue becomes more important while supplying with limited sources such as renewables. To overcome the problem, this study proposes a novel energy efficient driver for LED luminaires based on zero voltage switching (ZVS) single-ended primary inductance converter (SEPIC) technology. Driver and hence luminaires were designed to be fed from photovoltaic (PV) panels. In addition, an adaptive MPPT algorithm was developed to obtain optimum efficiency from supply system. SEPIC approach was preferred for MPPT application due to its advantages such as non-reversing polarity. This feature allows energy efficiency in corporation with ZVS. Proposed model was designed under PSIM platform with all components; PV panels, ZVS, SEPIC, and LED luminaires. A detailed analysis was performed by using system graphs under various operating conditions as different irradiance levels. Results show that proposed model is energy efficient and modular because of its low-volume structure. Therefore the model can lead smaller driver circuits with minimum losses.
References:
1. Tikhonov P.V. Energy-Saving LED Lighting System with Parallel Power Supply by Photovoltaic Modules and by Network// Light & Engineering,2020, Vol. 28, # 6, pp. 36–40. 2. Ozbay H., Efe S.B., Özer İ. PV System Design for Farm Houses: A Case Study in Bandirma// Int. Eng. Nat. Sci. Conf. (IENSC2019), 2019, pp. 710–717. 3. Efe S.B., Varhan D. Interior Lighting of a Historical Building by using LED Luminaires: A Case Study of Fatih Paşa Mosque// Light & Engineering, 2020, Vol. 28, # 4, pp. 77–83. 4. Djuretic A., Kostic M. Actual energy savings when replacing high-pressure sodium with LED luminaires in street lighting// Energy, 2018, #157, pp. 367–78. https://doi.org/10.1016/j.energy.2018.05.179. 5. Jiang Y., Li S., Guan B., Zhao G., Boruff D., Garg L., et al. Field evaluation of selected light sources for roadway lighting// J. Traffic Transp. Eng. (English Ed), 2018, #5, pp. 372–385. https://doi.org/10.1016/j.jtte.2018.05.002. 6. Yoomak S., Ngaopitakkul A. Optimisation of lighting quality and energy efficiency of LED luminaires in roadway lighting systems on different road surfaces// Sustain Cities Soc., 2018, #38, pp. 333–347. https://doi.org/10.1016/j.scs.2018.01.005. 7. Gerber D.L., Liou R., Brown R. Energy-saving opportunities of direct-DC loads in buildings// Appl. Energy, 2019, # 248, pp. 274–287. https://doi.org/10.1016/j.apenergy.2019.04.089. 8. Nestyorkina N.P., Zhuravlyova Y.A., Kovalenko O.Y., Mikayeva S.A. Comparative Analysis of the Characteristics of LED Filament Lamps for Household Lighting// Light & Engineering, 2020, Vol. 28, # 6, pp. 71–75. 9. Ayaz M., Yucel U., Erhan K., Ozdemir E. A Novel Cost-Efficient Daylight-Based Lighting System for Public Buildings: Design and Implementation// Light & Engineering, 2020, Vol. 28, # 6, pp. 60–70. 10. Elibol E., Ozmen O.T., Tutkun N., Kцysal O. Outdoor performance analysis of different PV panel types// Renew Sustain Energy Reviews, 2017, # 67, pp. 651–661. https://doi.org/10.1016/j.rser.2016.09.051. 11. Hegedьs J., Hantos G., Poppe A. Light output stabilisation of LED based streetlighting luminaires by adaptive current control// Microelectron Reliab., 2017, #79, pp. 448–456. https://doi.org/10.1016/j. microrel.2017.06.060. 12. Cengiz M.S., Yetkin S.. Thermal Analysis in Fixed, Flowed and Airless Environment for Cooling in LED Luminaires// Light & Engineering,2020, Vol. 28, # 6, pp. 28–35. 13. Huang B.J., Chen C.W., Ong C.D., Du B.H., Hsu P.C. Development of constant-power driving control for light-emitting-diode (LED) luminaire// Appl. Therm. Eng., 2013, #50, pp. 645–651. https://doi.org/10.1016/j.applthermaleng.2012.07.030. 14. Karafil A., Ozbay H., Oncu S. Design and Analysis of Single-Phase Grid-Tied Inverter with PDM MPPTControlled Converter// IEEE Trans. POWER Electron, 2020, # 35, pp. 4756–4766. 15. Jiang L.L., Srivatsan R., Maskell D.L. Computational intelligence techniques for maximum power point tracking in PV systems: A review// Renew Sustain Energy Rev., 2018, #85, pp. 14–45. https://doi.org/10.1016/j.rser.2018.01.006. 16. Sheik Mohammed S., Devaraj D., Imthias Ahamed T.P. A Novel Hybrid Maximum Power Point Tracking Technique Using Perturb & Observe Algorithm and Learning Automata for Solar PV System// Energy, 2016, #112,1096–1106. https://doi.org/10.1016/j.energy.2016.07.024. 17. Majstorovic M., Mrsevic D., Duric B., Milesevic M., Stevic Z., Despotovic Z.V. Implementation of MPPT Methods with SEPIC Converter// 19th Int. Symp. INFOTEH-JAHORINA, INFOTEH 2020, pp. 1–6. https://doi.org/10.1109/INFOTEH48170.2020.9066296. 18. Necaibia S., Kelaiaia M.S., Labar H., Necaibia A., Castronuovo E.D. Enhanced auto-scaling incremental conductance MPPT method, implemented on low-cost microcontroller and SEPIC converter// Sol. Energy, 2019, #180, pp. 152–168. https://doi.org/10.1016/j.solener.2019.01.028. 19. Chiang S.J., Shieh H.J., Chen M.C. Modeling and control of PV charger system with SEPIC converter// IEEE Trans. Ind. Electron, 2009, # 56, pp. 4344–4353. https://doi.org/10.1109/TIE.2008.2005144. 20. Raj A., Arya S.R., Gupta J. Solar PV array-based DC–DC converter with MPPT for low power applications// Renew Energy Focus, 2020, #34, pp. 109–119. https://doi.org/10.1016/j.ref.2020.05.003. 21. Unnikrishnan C.K., Raj C.R. High frequency quasi resonant SEPIC converter for wide range of operation// 2014 Int. Conf. Circuits, Power Comput. Technol. ICCPCT 2014, IEEE; 2014, pp. 984–989. https://doi.org/10.1109/ICCPCT.2014.7054958. 22. Oncu S, Ozbay H. Simulink model of parallel resonant inverter with DSP based PLL controller// Elektron Ir Elektrotechnika, 2015, #21, pp. 14–17.
Keywords
Recommended articles
Interior Lighting of a Historical Building by Using LED Luminaires: A Case Study of Fatih Paşa Mosque. L&E 28 (4) 2020
Experimental Design and Analysis of Adaptive LED Illumination System L&E, Vol.30, No.4, 2022